Author
|
Topic: More on GBC binary on FA (Read 79 times) |
|
Lalli
Junior Member
Posts: 2
I love YaBB 1 Gold!
|
 |
More on GBC binary on FA
« on: October 24th, 2001, 2:01pm » |
 
|
Why does a GBC binary file that has been written to a FA flash card made for GBA not run on the GBA when GBC cartridges work ?
How does the GBA sense the differense of GB and GBA carts ?
How do the GB cartridges work on the GBA, does the ARM emulate the GB HW or is the old CPU in the GBA to ?
Electronic difference between carts have nothing to do with the binary that is stored on them so I must asume that you could store GB binaries and then activate the GB emulation.
I have seen all kinds of answers were lack of knowlage is hidden behind "common sense" answers on these questions but I would like to see some real answers with details.
Thanks
|
|
 Logged |
|
|
|
Snubber
Guest
|
|
Re: More on GBC binary on FA
« Reply #1 on: November 12th, 2001, 7:50pm » |
|
From what I understand the gba contains an original Z80 chip in it, commonly found in the gbc and gb. If you look at your GBA carts you will see a little notch in the casing next to the connector. This notch prevents the cart from hitting a *physical* switch in the gba which, i belive, toggles between gb/gba. I have not seen any evidence of a software style switch. I think the only hope would be to write an actual emulator for the gba (most likely buggier than original hardware).
|
|
Logged |
|
|
|
Lalli
Junior Member
Posts: 2
I love YaBB 1 Gold!
|
|
Re: More on GBC binary on FA
« Reply #2 on: November 12th, 2001, 11:34pm » |
|
Hi, thanks for the reply
That would make sense, I don't know if the new GB Bridge has any electronics or just the switch/sensor notch, and shutting the power of the CPU that is not in use would make sense for power preservation.
But on http://www.gbaemu.com/ I saw that someone is writing a GB emulator for the GBA, it could be buggy but if it does the same job as the PocketNes 5 it will be good enough.
|
|
Logged |
|
|
|
|
